- Low watt density heating element gently warms your fermenting beer without scorching
- Keep your fermentation temperature consistent during the colder months or raise the temp on command for diacetyl rests
- Connect directly to the BrewBuilt X3 Uni Conical via the dedicated 2" tri-clamp port for effective, in-solution heating
- Smooth, stainless steel construction is easy to clean after use
- Compatible with all sizes of X3 Uni Conicals
Add this Immersion Heater to your BrewBuilt X3 Uni Conical for the ultimate control over your fermentation temperature. Connecting directly to the X3's dedicated 2" T.C. port at the side of the cone, the Immersion Heater will provide gentle, effective heating whenever you need it. A must-have for brewers living in colder climates or if you want the peace of mind that your temperature will never drop too low for your ale or kveik strains regardless of the time of year. Heating your fermenter on command can also come in handy if you need to bring your chilled wort up to temp before pitching, or if you need to perform a diacetyl rest after fermentation is complete.
We recommend pairing the Immersion Heater with a temperature controller like the Inkbird so it will only be powered on as needed. If using the heater alongside the IceMaster Max 2 glycol chiller, you can insert the Max 2 temp probe into the X3's thermowell first and then insert the Inkbird's probe behind it. Both probes will be deep enough to get accurate temp readings and heating & cooling will be regulated by independent controllers.
Another setup option is using the IceMaster 100 and the BrewBuilt Chiller Pump Kit. The IceMaster 100 does not come with built-in pumps so you can add your own submersible pumps as needed. Each Chiller Pump Kit includes an Inkbird controller and a submersible pump. The heater and pump are then both plugged into the Inkbird so heating & cooling are regulated by a single controller.
The element runs at 125 watts when powered with the included IEC x 110V plug adapter (not pictured).
Specs:
- 125W @ 110-120V (500W @ 220-240V)
- Total Length: 16"
- Length in Conical: 12"
- Cord Length: 5 ft.
KegLand Part Number: KL35941
Please Note: The Warmking Wizard Wand is only compatible with X3 BrewBuilt Conicals. If interested in heating a previous generation conical, see the BrewBuilt Conical Heaters here.